We want to finish our square-sampler ?
We arrived at about the half point after the first tunnel, which we decided to call pierced simple point, we were back to work the stitch padded.
This is the first line after the point pierced. It do the other two:
Now let's try another place perforated colon and skip work two, in the next round we have two points in space, on board.
four lines of this point, here is how:
As you can see, the center tends to "go up a bit 'to the sides, this effect is canceled when you veer close the work down.
Now go back to work stitch stuffed we have to make three points in space and a point between the two stitch. In this way we will maintain the same number of points of the beginning. Because when you set up the work missed only two points, would think of to make two even in empty space, but as between the two stitch there is only room for one point, he must make three space, otherwise remain a few points and the work is pulled. (I do not know if I could explain it, working it soon becomes clear)
We still stitch line and get this:
As you can see, the bottom remains a bit 'of space, but it is better to close here, so that in fixing the points at the bottom, you pull a little 'work and open up good points of the holes drilled.
Fix points to the bottom is easy, you do an overlock, entering all the ribs of the stitch.
It continues throughout the last row.
Here we see the difference between the first part was already fixed, and the rest. The points are pierced highlighted after closing.
And here's the finished work!
And as always, HERE you can download the tutorial in PDF
0 comments:
Post a Comment